Wooden Camera Cableless Gold Mount for RED WEAPON / SCARLET-W / RAVEN

The Wooden Camera Cableless Gold Mount for RED WEAPON / SCARLET-W / RAVEN is a cable-free, Gold Mount battery plate system designed for use with RED WEAPON, EPIC WEAPON (EPIC-W), SCARLET WEAPON (SCARLET-W), and RAVEN cameras.

This system utilizes an Anton/Bauer brand battery plate with (2) P-Tap ports and the Wooden Camera pogo interface module. The assembly attaches without tools, directly to the back of the RED camera, Base Expander Module, REDVolt Expander Module, and some third party modules (such as OMODs).

This system can be configured in center, high, and low modes. Center mode is most appropriate for regular use. High and Low mode should be reserved for special circumstances. High mode positions the battery plate above the back of the camera. Low mode positions the plate flush with the very bottom of the camera body, meaning Gold Mount batteries would actually stick out below the camera body.

The Cableless Gold Mount will communicate charge percentage or voltage data to the camera's LCD display. Intelligent batteries like Anton/Bauer Dionics, Switronix, and other batteries utilizing Anton/Bauer protocol, will allow the module to communicate percentage data and estimated run time. Non-communicative batteries will only provide voltage data to the camera through the Wooden Camera module.

IMPORTANT NOTE: When using Cableless and D-Box battery modules it is important to know the amount of power your batteries are capable of providing. A RED Brick battery can supply up to 10A, with the camera generally consuming 4-6A in standard configuration.

Although the remaining power is available from the P-Tap, LEMO compatible, Fischer connectors, etc., it is best to limit the power draw to 4A or less for best results. Consuming more power than a battery is capable of providing will cause the battery to shut down.

Specifications:

• Battery Mount: Gold Mount (3-stud)
• Weight: 1 lb (453.6 g)
• Dimensions: 4.7" x 0.98" x 3.4" (120mm x 25mm x 86mm)

NOTE: Connectors used in this assembly are not manufactured by LEMO but are made to the same specifications and are LEMO compatible.