Wooden Camera D-Box for Sony Venice - Gold Mount

Wooden Camera D-Box for Sony Venice - Gold Mount is a power distribution box for your Sony VENICE camera that mounts directly to the back of your camera. The D-Box main unit attaches to the back of the AXS-R7 or to the V-Mount plate on your camera rear and the Power Strip portion attaches to the top right side of the camera via a 3-Pin Fischer and the tape hook threaded hole.

This D-Box provides the following connections:

• 2x D-Tap (12V, unregulated)
• 2x 2-Pin LEMO (12V, unregulated) with ARRI standard wiring
• 2x 3-Pin Fischer with Run/Stop (24V)
• 1x USB (5V)
• 1x 4-Pin XLR for DC power input

This box is for Gold Mount only.

The 3-Pin Fischer connection offers a regulartor built-in to convert battery voltage to 24V. This connection also includes a maxium 3A surge, 2.5A sustained shared between connectors.

The 4-Pin XLR DC Input provides hot swappable capabilities with your on-board battery. If can provide power to your accessories and camera without a brick battery attached.

Connectors on the D-Box Power Strip are contoured to match the camera profile and connector angle which allows for all cables to be installed with no collisions. The module communicates with the camera and allows any ARRI standard start/stop trigger to be used with the 3pin Fischer port including your ARRI UMC-4 or your WCU-4. The DC input on the D-Box is the same as the camera's 4-Pin XLR connector allowing for an AC Power Supply, External Power Plate, or VCLX block battery to be connected to power accessories and camera during a battery change. When both battery and DC input are utilized, the D-Box defaults to the DC input, leaving the onboard battery fully charged.

Physical fuses have been replaced by a processor controlled amp limit which is settable to 3.8, 5.8, or 9 amps using the slide switch on the operator's side. Should the user exceed the set current for accessories, only the accessory outputs are disabled leaving the camera running normally. Once the current load has been reduced by either removing accessories or reconfiguring, the reset button can be pressed to enable accessory power again.

The "DC IN" and "BATT" LEDs are dual LEDs. This means the LED if battery voltage is above 12.5V the LED will be green. If the battery voltage is below 12V, the LED will be red. If the battery voltage is between those values, the LED will be orange (red + green). Flashing may occur during phase transition.

Highest quality Anton Bauer components are used in the Gold Mount assembly and the unibody power plate design is both extremely durable and lightweight.

Connectors used in this assembly are not manufactured by LEMO but are made to the same specifications and are LEMO compatible.

• Dimensions: 1.5 x 4.5 x 5.25" (31.8 114.3 x 133.35 mm)
• Weight: 1.065 lb (484 g)